This flat pin header connector got ripped of the circuit board. I'm not sure what type of header pins it uses and I could not remove the plastic housing from the pins, does anyone know how I find a replacement for this connector?
What is the pitch of the pins? 2.54mm (0.1")? Possibility (https://www.robotics.org.za/JST-XH-3P-90)? Another (https://sa.rsdelivers.com/product/jst/s3b-xh-alfsn/jst-xh-series-right-angle-through-hole-pcb-header/1724923??srsltid=AfmBOoqTEC6De651NuZlbW9esbWvwuWhrJgNjPLK4Ip8ikcZY7MEKKGn)?
Quote from: Chris Savage on Nov 10, 2025, 11:25 PMWhat is the pitch of the pins? 2.54mm (0.1")? Possibility (https://www.robotics.org.za/JST-XH-3P-90)? Another (https://sa.rsdelivers.com/product/jst/s3b-xh-alfsn/jst-xh-series-right-angle-through-hole-pcb-header/1724923??srsltid=AfmBOoqTEC6De651NuZlbW9esbWvwuWhrJgNjPLK4Ip8ikcZY7MEKKGn)?
Famous last words, but might be 0.1" I think, If so, I think replacing that should be super simple.
I was able to repair the controller. I was able to find some 90° header pins that were the correct spacing/pitch but are not as thick as the pins that where in the circuit board. I was also not able to get the plastic connector off the old pins so there is no "locking" connection, but hey, it works. Thanks for the responses.
Quote from: Jason D. on Nov 11, 2025, 11:07 PMI was able to repair the controller. I was able to find some 90° header pins that were the correct spacing/pitch but are not as thick as the pins that where in the circuit board. I was also not able to get the plastic connector off the old pins so there is no "locking" connection, but hey, it works. Thanks for the responses.
Welcome. Maybe a shot of the "Hot Snot" as Dave Jones puts it on the EEVBlog, aka Hot Glue, might help keep it in place.