Battery Dispenser AA and AAA / Lid for 9V and CR 2016-2430 batteries (https://makerworld.com/en/models/1714487-battery-dispenser-aa-and-aaa#profileId-1819584)
20260707_222122_640x480.jpg
As you can see, I printed the optional lid for 9V and CR coin cell batteries.
20260707_222552_640x480.jpg
Not sure where my CR2032 batteries are, but I have the rest put in.
Handy.
That Gray filament I have doesn't print as clean as the other colors. I may reprint this in a better color. ::)
We buy our AA, and AAA, cells in Sam's Club 48-packs. How many cells does yours hold? There is one commenter who stretched out his print, in the Z-axis to hold more cells, but then the ramp was slanted too high and they didn't hold as well.
Also, several people mentioned that they enlarged the print (apparently you are only able to do that in the Studio) by 3% so that the cells fit better/more easily.
It does look nice, though - I may print one.
The cells fit perfectly as shown in the photo. I can't fit all my AA batteries in it at once, but it definitely holds all my AAA. The four 9V batteries is all I have. I get my batteries in bulk from BJs, though the 9V batteries are from a buddy (Procell). Not sure where they came from. I have a few CR2032 cells somewhere.