AMS Dry Kit + Full Hygrometer Reading Area (https://makerworld.com/en/models/149506-ams-dry-kit-full-hygrometer-reading-area#profileId-163128)
20260703_121015_640x480.jpg
I printed this set for my P1S, since I was having issues with the spools that were on the A1. Unfortunately, during printing, two parts got discombobulated!
20260703_121333_640x480.jpg
One part got all stringy, while the other fell over, probably because of the stringy crap.
20260703_121310_640x480.jpg
Although these parts printed, if you look close you can still see that they didn't print very clean.
20260703_121318_640x480.jpg
I've had more issues with the matte gray than any other color filament.
20260703_191030_640x480.jpg
I did end up printing the damaged pieces again, and this time they printed.
20260710_202232_640x480.jpg
Once the hydrometer came in, I got all the modules installed in the P1S.
20260710_202247_640x480.jpg
This is right after installing the modules, but the next morning this gauge reads 19% humidity,