These are my latest prints to jazz up my workshop. ;D
That "genius at work" sign has a lot of stringing in the black filament. I've seen that recently, but forget where, and I cannot remember how the person in that video solved it.
Have you figured out how that happened, or how to prevent it in future prints?
Other than that, I like it - especially the exception of "if you have snacks." :P
Quote from: granz on Aug 26, 2026, 06:18 AMThat "genius at work" sign has a lot of stringing in the black filament. I've seen that recently, but forget where, and I cannot remember how the person in that video solved it.
I have not identified the issue. I assume it's the print profile for that model, based on that similar prints with the same black filament do not seem to have that same issue. Based on that, I rated the print profile appropriately. Often stringing is a result of damp filament, however, on the P2S this should be impossible,
especially with the addition of the dry boxes. So I just can't be sure.
On that note, I had an issue recently while printing this model (this is the
second print), which resulted in my Hotend becoming clogged. Typically these "signs" take about 1.5 hours, depending on the size. This one took over 4 hours. I think the design of the model and the print profile are inefficient IMHO.
lol