Bambu Lab's A1 One Year Later...

[Chris Savage]

I spent some time assembling each printer.

You cannot view this attachment.

Here I have one P2S done and ready, while I am wrapping up the second P2S.


You cannot view this attachment.

Here both printers are assembled and ready to print. Sadly, my wife is sleeping right below them, so I have to wait until tomorrow to print, though the calibration is done on both units.


As for the Den computer desk...

You cannot view this attachment.

I have some boxes to put away from the assembly of the new printers, but then this desk will be devoted to Linux / Raspberry Pi stuff (on the left side, anyway).

[granz]

Nice, looking good Chris.

[Chris Savage]

Nice, looking good Chris.

I'll be posting a review on these soon. I had a couple minor glitches...one during setup and one during my first print, that I hope never happens again!

You cannot view this attachment.

First print for each P2S is a desiccant box for the AMS that supports a round hydrometer. There are more parts to print. The parts for the first printer are in red.


You cannot view this attachment.

The parts for the second printer are in purple.