AMS Dry Kit + Full Hygrometer Reading Area

[Chris Savage]

AMS Dry Kit + Full Hygrometer Reading Area

You cannot view this attachment.

I printed this set for my P1S, since I was having issues with the spools that were on the A1. Unfortunately, during printing, two parts got discombobulated!


You cannot view this attachment.

One part got all stringy, while the other fell over, probably because of the stringy crap.


You cannot view this attachment.

Although these parts printed, if you look close you can still see that they didn't print very clean.


You cannot view this attachment.

I've had more issues with the matte gray than any other color filament.

[Chris Savage]

You cannot view this attachment.

I did end up printing the damaged pieces again, and this time they printed.


You cannot view this attachment.

Once the hydrometer came in, I got all the modules installed in the P1S.


You cannot view this attachment.

This is right after installing the modules, but the next morning this gauge reads 19% humidity,