Need a laser cut and a 3d print done.

[MicroNut]

Here are some pictures

The first three are from the stl files I got from Terasic's website to make the case.The DE10-Lite snaps into the bottom piece wile the top piece is friction fitted on the mounting posts for the acrylic plate. It is great for transporting and for any onboard development. If I want to access the 40 pin header or the Arduino header I need to remove the top piece.

The tray came from a community site and holds the board by friction fitting to the bottom mounting posts and is a bit more secure than the case if I want to access the headers.

I did recently found out the Raspberry Pi Cobbler can be used to breakout the 40 pin header to a breadboard so expanding to external hardware will be a lot easier to do.