A1 Printer Issue

[Chris Savage]

My A1 was down on May 6th after I sent a print home, then received an extruder error about 20 minutes later. I wasn't home to deal with it, so I cancelled. When I got home, this is what was on the print bed.

You cannot view this attachment.

At first I wasn't sure what happened. But I was in a hurry to finish the print, so I moved the new roll of filament to the P1S and everything printed fine.


You cannot view this attachment.

The ejector / deflector was wadded full of filament!


You cannot view this attachment.

It took me several days to get back to this, and my first few attempts at cleaning the nozzle failed to yield results. Finally, I replaced the Hot End and now we're back up and running.