Bambu Lab's A1 One Year Later...

[Chris Savage]

I spent some time assembling each printer.

You cannot view this attachment.

Here I have one P2S done and ready, while I am wrapping up the second P2S.


You cannot view this attachment.

Here both printers are assembled and ready to print. Sadly, my wife is sleeping right below them, so I have to wait until tomorrow to print, though the calibration is done on both units.


As for the Den computer desk...

You cannot view this attachment.

I have some boxes to put away from the assembly of the new printers, but then this desk will be devoted to Linux / Raspberry Pi stuff (on the left side, anyway).

[granz]

Nice, looking good Chris.

[Chris Savage]

Nice, looking good Chris.

I'll be posting a review on these soon. I had a couple minor glitches...one during setup and one during my first print, that I hope never happens again!

You cannot view this attachment.

First print for each P2S is a desiccant box for the AMS that supports a round hydrometer. There are more parts to print. The parts for the first printer are in red.


You cannot view this attachment.

The parts for the second printer are in purple.

[granz]

Nice, I like it. And, the price is not too bad, either. So, the first filaments that you purchase is the ones with the spools, and then you get refills? Or, do you just purchase a few/several empty spools and then use the refills on those empty spools?

I originally bought the spools. Then when they were empty, I gave them away to someone else I knew had an A1. At that time I didn't know how the refills worked, so I didn't think I would ever get them. When I found out how easy it was, I regretted giving my spools away and actually printed a couple (there are several styles online) and they worked perfectly. After so much printing, I started having empty spools and started buying the replacements as refills, which generally cost less.

P.S. - It takes very little to print the spools yourself. Mine came out perfect and worked for a while until I passed them on to someone else who needed a couple of spools for refills.

I tried printing an empty spool for one of my refill rolls. Unfortunately, while it looks fine, it does not screw together properly - the halves keep coming apart, and won't keep the filament in place.

Could you direct me to the actual MakerWorld (or where ever you got it) project for the spools that you printed?

Thanks.

[Chris Savage]

Could you direct me to the actual MakerWorld (or where ever you got it) project for the spools that you printed? Thanks.

Bambu Reusable Hex Spool with Label - This is the exact one. I made two of these before I started accumulating empty spools. It may be possible to bring you an extra spool when I come to the meetup.