Bambu Lab's A1 One Year Later...

[MicroNut]

@granz. I will bring it! The display only is half lit up. One side appears off. I did a little googling and most sites said it may be just be that the cable is loose.

Jim did a lot of upgrade mods to it. Heated plate, stepper motors with finer precision, LCD controller. Knowing Jim, he had only top of the line upgrades on it. So even though it is older tech it'll be a good starter. Once I get it going I'll probably use a Raspberry PI 3 with octoprint and a camera to control it. I do have some filament Jim gave me but it has been in the basement for 2 years so it may not be any good.

Jim will be there so he can tell you what improvements he's done.